Standard Type
The standard type is the most widely used. It is made up of the following
two series L Series : For Metric System ; Japanese specifications LE Series :
For Metric System ; European specifications
Miniature Type
Coping with the pressing needs of the times, which demand smaller, lighter and
shorter products, this series includes variations of 3, 4 and 5 mm inside
diameter bearings.
Non-Rust Type
Non-Rust type, M series is better quality, and antirust than stainless type,
also price is economical than stainless steel. ML, ML...UU
With Oil Holes Type
With Oil Holes Type on the outer sleeve can easily and completely lubricate in
every ball rows. L-OH (with sealed), ML-OH(with sealed)
Open Type Removing one line portion of balls, the open type creates a
guiding mechanism with high rigidity, while preventing axial deflection. The
open type is similar to our adjustable clearance type. A fitting without play
against a shaft can be maintained, while allowing installation of a supporting
stand beneath the shaft to avoid deflection. L-OP, LE-OP
Adjustable Clearance
Type Equipped with slit in the axial direction on an outer sleeve, a
sustained fitting condition without looseness can be obtained, after being
installed into a housing where the inside diameter can be adjusted. L-ADJ,
LE-ADJ
Sealed Type
Lip-type, special synthetic rubber sealing is provided on either, one, or both
ends of a bearing, designed for such problems as heavy dust or possible
intrusion of foreign matter. Also, this type prevents grease leakage out of the
bearings. L-U(sealed on one end), UU(both ends sealed), LE-U, UU ML-UU
|